Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 4
INSTALLATION INSTRUCTION
Aether 3.5” Shallow Recessed Housing and Trims
HR-3LED-H17A
DOWNLIGHT INVISIBLE TRIM INSTALLATION
1. When installing in drywall, cut a hole 4 5/8” in the drywall.
Note: 1 1/2” inch maximum ceiling thickness.
2. Raise the invisible trim frame aligning tab to slot in housing,
and put plaster shield inside (See FIG.9).
3. Secure the invisible trim frame to the housing, ush up
against the ceiling using the screws supplied (See FIG.10).
4. Apply plaster or spackle over Invisible frame and sand surface
when dry for a nished look (See FIG.11).
5. Remove the plaster cover when nishing is completed
(See FIG.12).
6. Install light engine into the housing by rotating it clockwise
onto stud (Fig.13)
Connect light engine and housing power connectors (Fig.14).
7. Raise the invisible trim assembly up to trim frame until the
trim ring is ush to the trim frame (See FIG.15).
FIG.9
FIG.10
FIG.11 FIG.12
FIG.15
Slot in housing
Tab
Plaster Shield
Remove plaster shield
FIG.13
FIG.14