Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 7
LED AND DRIVER REPLACEMENT
1. Remove the trim or invisible trim
a. Remove the trim or invisible trim as shown below (FIG.24 & 25).
Remove the trim by pulling the trim’s edge
To remove invisible trim:
Remove the invisible trim by gently prying
between the invisible trim and lens
Trim Invisible Trim
INSTALLATION INSTRUCTION
Aether 3.5” Shallow Recessed Housing and Trims
HR-3LED-H17A
FIG.24 FIG.25
2. Replace Driver
a. Remove the LED module by rotating the LED module counterclockwise and pull out the LED module from housing (FIG.26),
then loosen wing nuts on the side of driver (FIG.27).
b. Tilt driver downward and remove from housing (FIG.28).
c. Remove screws to replace driver with new, rewire according to code and reinstall (FIG.29).
Wing Nuts
Screws
FIG.27
FIG.28 FIG.29
LED Module
Wire
connector
FIG.26