Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 8
INSTALLATION INSTRUCTION
Aether 3.5” Shallow Recessed Housing and Trims
HR-3LED-H17A
FIG.29 FIG.30 FIG.31
Replace LED (Adjustable and Wall Wash Trim)
a. Remove the trim by pulling the trim’s edge (FIG.29)
b. Release the two screws from the light engine (FIG.30), remove the safety cable and use scissor to cut the LED input
c. Follow the steps (FIG.31) by removing #2, #3 then #4 screws from the light xture. Replace the LED module.
3
2
4
LED
1
3. Replace LED (Downlight Trim)
a. Disconnect wire connector, rotate the LED module counterclockwise and pull out to remove the LED module from housing (FIG.30).
b. Replace the LED by unscrewing the bracket, removing lens and reector. Then, replace the LED (FIG.31 & 32).
LED Module
Insert black wire (-)
to round input
Insert red wire (+)
to square input
Wire
connector
Housing
LED
Reector
Lens
Bracket
Screws
Connector
LED
FIG.30 FIG.31 FIG.32