Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1 Emission Control system Information 4
- 2 Safety Information 5
- 3 Technical Data 13
- 4 Operation 16
- 5 Maintenance 20
- 5.1 Maintaining the Emission Control System 20
- 5.2 Periodic Maintenance Schedule 20
- 5.3 Spark Plug 22
- 5.4 Air Cleaner 23
- 5.5 Engine Oil 24
- 5.6 Adjusting Engine Speed 24
- 5.7 Carburetor Adjustment 25
- 5.8 Cleaning Sediment Cup 25
- 5.9 Drive Belt 26
- 5.10 Exciter Lubrication 27
- 5.11 Cleaning Plate 27
- 5.12 Lifting Machine 28
- 5.13 Transporting Machine 29
- 5.14 Storage 29
- 5.15 Troubleshooting 30
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 3. Technical Data
- 4. Operation
- 5. Maintenance
- 5.2 Periodic Maintenance Schedule
- Machine Maintenance
- 5.3 Spark Plug
- 5.4 Air Cleaner
- 5.5 Engine Oil
- 5.6 Adjusting Engine Speed
- 5.7 Carburetor Adjustment
- 5.8 Cleaning Sediment Cup
- 5.9 Drive Belt
- 5.10 Exciter Lubrication
- 5.11 Cleaning Plate
- 5.12 Lifting Machine
- 5.13 Transporting Machine
- 5.14 Storage
- 5.15 Troubleshooting
- Blank Page
- Blank Page
VP 1340A/VP 1550A Operation
wpm_tx001087gb.fm 18
4.4 To Start
See Graphic: wc_gr000014
4.4.1 Open fuel valve by moving lever to the right (a1).
Note: If engine is cold, move choke lever to close position (b1). If
engine is hot, set choke to open position (b2).
4.4.2 Turn engine switch to “ON” (e1).
4.4.3 Open throttle by moving it slightly to left (d1).
4.4.4 Pull starter rope (c).
Note: If the oil level in the engine is low, the engine will not start. If this
happens, add oil to engine. Some engines are equipped with an oil
alert light (f) that will come on while pulling the starter rope.
4.4.5 Open choke as engine warms (b2).
4.4.6 Open throttle fully to operate.
4.5 To Stop
See Graphic: wc_gr000014
4.5.1 Reduce engine RPM to idle by moving throttle completely to right (d2).
4.5.2 Turn engine switch to “OFF” (e2).
4.5.3 Close fuel valve by moving lever to the left (a2).