Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1 Emission Control system Information 4
- 2 Safety Information 5
- 3 Technical Data 13
- 4 Operation 16
- 5 Maintenance 20
- 5.1 Maintaining the Emission Control System 20
- 5.2 Periodic Maintenance Schedule 20
- 5.3 Spark Plug 22
- 5.4 Air Cleaner 23
- 5.5 Engine Oil 24
- 5.6 Adjusting Engine Speed 24
- 5.7 Carburetor Adjustment 25
- 5.8 Cleaning Sediment Cup 25
- 5.9 Drive Belt 26
- 5.10 Exciter Lubrication 27
- 5.11 Cleaning Plate 27
- 5.12 Lifting Machine 28
- 5.13 Transporting Machine 29
- 5.14 Storage 29
- 5.15 Troubleshooting 30
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 3. Technical Data
- 4. Operation
- 5. Maintenance
- 5.2 Periodic Maintenance Schedule
- Machine Maintenance
- 5.3 Spark Plug
- 5.4 Air Cleaner
- 5.5 Engine Oil
- 5.6 Adjusting Engine Speed
- 5.7 Carburetor Adjustment
- 5.8 Cleaning Sediment Cup
- 5.9 Drive Belt
- 5.10 Exciter Lubrication
- 5.11 Cleaning Plate
- 5.12 Lifting Machine
- 5.13 Transporting Machine
- 5.14 Storage
- 5.15 Troubleshooting
- Blank Page
- Blank Page
VP 1340A/VP 1550A Maintenance
wpm_tx001088gb.fm 26
5.9 Drive Belt
See Graphic: wpmgr005992
On new machines or after installing a new belt, check the belt tension
after first 20 hours of operation. Check and adjust the belt every 50
hours thereafter.
To adjust the belt:
5.9.1 Loosen the two screws (a) on the beltguard, then remove the
beltguard, keeping the screw assemblies captured on the beltguard.
5.9.2 Loosen the four nuts (b) which hold the engine to the console, and the
screw (c) which holds the beltguard back to the console.
5.9.3 Slide the engine backward (towards the handle) to tighten the belt,
forward to loosen the belt.
5.9.4 Adjust the belt so that it deflects 10–13 mm (d) when pressed midway
between the belt pulleys.
5.9.5 Make sure that the clutch pulley (f) and the exciter pulley (e) are in
alignment. Place a straight edge against the exciter pulley (e) and
move the engine so that the two pulleys are parallel.
5.9.6 Torque all nuts and screws to 20.5 Nm as you reassemble the
machine.
wpmgr005992
a
b
d
c