Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1 Emission Control system Information 4
- 2 Safety Information 5
- 3 Technical Data 13
- 4 Operation 16
- 5 Maintenance 20
- 5.1 Maintaining the Emission Control System 20
- 5.2 Periodic Maintenance Schedule 20
- 5.3 Spark Plug 22
- 5.4 Air Cleaner 23
- 5.5 Engine Oil 24
- 5.6 Adjusting Engine Speed 24
- 5.7 Carburetor Adjustment 25
- 5.8 Cleaning Sediment Cup 25
- 5.9 Drive Belt 26
- 5.10 Exciter Lubrication 27
- 5.11 Cleaning Plate 27
- 5.12 Lifting Machine 28
- 5.13 Transporting Machine 29
- 5.14 Storage 29
- 5.15 Troubleshooting 30
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 3. Technical Data
- 4. Operation
- 5. Maintenance
- 5.2 Periodic Maintenance Schedule
- Machine Maintenance
- 5.3 Spark Plug
- 5.4 Air Cleaner
- 5.5 Engine Oil
- 5.6 Adjusting Engine Speed
- 5.7 Carburetor Adjustment
- 5.8 Cleaning Sediment Cup
- 5.9 Drive Belt
- 5.10 Exciter Lubrication
- 5.11 Cleaning Plate
- 5.12 Lifting Machine
- 5.13 Transporting Machine
- 5.14 Storage
- 5.15 Troubleshooting
- Blank Page
- Blank Page
Maintenance VP 1340A/VP 1550A
wpm_tx001088gb.fm 29
5.13 Transporting Machine
See Graphic: wpmgr006042
To avoid burns or fire hazards, let engine cool before transporting
machine or storing indoors.
5.13.1 Turn fuel valve to the off position and keep the engine level to prevent
fuel from spilling.
5.13.2 Tie down machine on vehicle to prevent machine from sliding or tipping
over. Tie machine to vehicle at points shown on graphic.
5.14 Storage
If plate is being stored for more than 30 days:
5.14.1 Remove loose stones and dirt from plate.
5.14.2 Clean engine cylinder cooling fins.
5.14.3 Clean or replace air filter.
5.14.4 Change exciter oil.
5.14.5 Change engine oil and follow procedures described in engine manual
for engine storage.
5.14.6 Cover plate and engine and store in a clean, dry area.
WARNING
wpmgr006042