User manual

EN
SinePower Connecting the inverter
43
A
8.3 Mounting the inverter
➤ Hold the inverter against the installation location and mark the fastening
points (fig. 3 A, page 4).
➤ Attach the inverter using your chosen fastening method (fig. 3 B,
page 4).
9 Connecting the inverter
9.1 General instructions
!
 When installed in vehicles or boats, the inverter must be connected to the
chassis or earth.
 When setting up a socket distribution circuit (mains setup), comply with
the applicable regulations.
 Only use copper cables.
 Keep the cables as short as possible (< 1 m).
NOTICE!
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
WARNING!
 The inverter may only be connected by a qualified workshop.
The following information is intended for technicians who are
familiar with the guidelines and safety precautions to be ap-
plied.
 Never use the inverter on vehicles where the positive terminal
of the battery is connected to the chassis.
 If you do not fit a fuse to the positive cable, the cables can
overload, which might result in a fire.