Installation manual

29
Installation
CoolAi
r
6.2 Steps for installation
a
Caution
The manufacturer only assumes liability for parts included in the scope of
delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
a
Caution
Check whether the roof of the vehicle is able to support the weight of a
person before climbing onto it. Ask the vehicle manufacturer about the
permitted roof loads.
6.2.1 Removing the sunroof
➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
I
Note
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2 Preparing unit fastening (Iveco Stralis AS³ only)
➤ Enlarge the 12 existing ∅ 6.5 mm holes for fastening the sunroof to a
diameter of 8.5 mm.
6.2.3 Attaching the seal for the cab roof
a
Caution
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape to the cab roof, following the outline of
the sunroof (fig. 3 on page 3):
– CA850S lveco Stralis AS/AT: insulating tape 10 x 25 mm
– CA850S lveco Stralis AS³: insulating tape 35 x 20 mm
➤ Provide the abutting edge and the top edge of the insulating tape with
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
CA-850S_EBA_Iveco.book Seite 29 Mittwoch, 15. Juni 2011 5:44 17