Installation manual

Installation
CoolAi
r
36
✓ -- flashes in the digital display.
➤ Press the + button.
✓ The digital display shows 00.
➤ Press the Operating Mode button (fig. 6 on page 4, item 4) to
confirm your entry.
✓ The parameters set in configuration mode are reset to the default
setting.
✓ You are now in menu level 4 and can use the + and – buttons to switch
between menu levels.
6.3.6 Menu level 5: Temperature unit display
The system can display the room temperature in °C or °F. This parameter
can be configured:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 32).
✓ The first digit of the display (fig. 6 on page 4, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + ( fig. 6 on page 4 , item 6) four times to switch to menu
level 5 .
➤ Press the Operating Mode button (fig. 6 on page 4, item 4) to
change the parameters.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons ( fig. 6 on page 4 , item 6 and 7) to select the
temperature unit that the system should display.
➤ Press the Operating Mode button (fig. 6 on page 4, item 4) to
confirm your entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 5 again and can use the + and – buttons to
switch between menu levels.
CA-850S_EBA_Iveco.book Seite 36 Mittwoch, 15. Juni 2011 5:44 17