Instruction manual

EN
CR50, CR 65, CR80, CR110, CR140 Installing and connecting the refrigerator
41
➤ Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable
screws:
➤ Remove the blanking plugs (fig. 7 2, page 6).
➤ Push the refrigerator into the recess.
➤ Use suitable screws (fig. 7 1, page 6) to fix the refrigerator in place.
➤ Press the blanking plugs (fig. 7 2, page 6) into the openings.
7.2 Undo the lock
The refrigerator has a locking mechanism (fig. 9 1, page 6) which is also
used, to protect it during transport. The following settings are possible:
a
Caution
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
 Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
 Vent (turn wheel anti-clockwise to the end stop): The door is slightly open,
but fixed in position.
Use this position, if you are not going to use the appliance for a long time.
7.3 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. b, page 8 to fig. d, page 8, to change the
hinges.
_cr-kuehlschraenke.book Seite 41 Montag, 27. Februar 2012 12:46 12