Specifications

INSTALLATION

The refrigerator must sit upright for a minimum of 8 hours

prior to installation.

. PREPARE THE SITE

The refrigerator should have solid, secure support. Measure

the opening to determine that you have proper clearance for

installation. Do not install in direct sunlight or near a gas stove,

heater, or other heat-generating device. Avoid hot water lines

or warm air ducts.

Make sure that sufficient electrical power is connected per

electrical requirements as outlined. Also be sure that you have

enough length of wire to service the unit outside of the

opening. Ensure that sufficient ventilation is provided per

ventilation requirements. Verify that there is enough room for

the door to swing open with the refrigerator installed.

2. REVERSING THE DOOR SWING.

If the door needs to be reversed, remove the four screws that

hold the top front panel.

Remove the top hinge and panel support by the three screws

that hold them. Lift door off bottom hinge.

Remove the bottom hinge by three screws.

Reinstall the bottom hinge on the opposite side. Install door on

hinge and close door. Reinstall top hinge and panel support on

opposite sides. Reinstall top panel.

3. INSTALL THE FRAME.

Use the screws provided.

• P

age