User`s manual

www.wagan.com

Elite 180W Pure Sine Inverter by Wagan Tech

Wagan and wagan.com are trademarks used by Wagan Corporation

multiply the amps by 120 (120V AC) to determine the watts. For example, an

appliance rated at 0.5 amps will draw 60 watts.

WATTS = VOLTS × AMPS

Remember to consider the startup surge that motorized appliances will cause. Do

not exceed the 360 watt momentary surge rating of this inverter. This can cause

immediate overload shut down and or blow a fuse. A fuse protects the Accessory or

Lighter Socket.

Connecting the Inverter

1. Connect the red and black prongs of the supplied DC Adapter Cord into the

inverter.

Be sure to insert them into the correct polarity terminals on the rear of the

inverter. Reverse polarity connection will blow the fuse in the inverter and can

permanently damage to the inverter. Damage caused by reverse polarity will

void the warranty.

2. Connect the Plug end of the DC Adapter Cable into your vehicle’s 12V DC

accessory outlet. You may need to place the ignition switch to Accessory

Position if the vehicle engine is not operating.

3. Plug the AC appliance cord into the inverter’s AC receptacle, and/or your

USB appliance into the USB Power Port.

4. Place the ON/OFF power switch in the ON position. The green LED should

turn on, indicating the inverter is powered and operating normally.

5. While the Inverter is not in use, place the inverter’s ON/OFF Power Switch

to the OFF position, and optionally unplug the DC Adapter cable from the

vehicle’s DC outlet.