User Manual
English
8 © Wagner Spray Tech - All Rights Reserved
Maintenance
Cleaning the Filter:
IMPORTANT: Before every use, you should
inspect the air lter in the turbine to see if it
is excessively dirty. If it is dirty, follow these
steps to replace it.
IMPORTANT: Never operate your unit
without the air lter. Dirt could be sucked in
and interfere with the function of the unit.
1. Remove the dirty lter from the turbine and
replace with new one. The smooth side of the
air lter must be placed toward the turbine.
Troubleshooting
PROBLEM CAUSE SOLUTION
Problem A: Little or no
material ow
1. Nozzle clogged.
2. Suction tube clogged.
3. Material ow setting too low.
4. Suction tube loose.
5. Air vent on suction tube blocked.
6. No pressure build up in container.
7. Air lter clogged.
8. Spray material too thick.
1. Clean.
2. Clean.
3. Increase material ow setting.
4. Remove and replace as tightly
as possible.
5. Clean (see page 7)
6. Tighten container.
7. Change
8. Thin.
Problem B: Material
leaking
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal missing or worn.
4. Material build-up on air cap and
nozzle
1. Tighten.
2. Replace.
3. Replace.
4. Clean.
Problem C: Spray pattern
too thick, runs and sags
1. Material ow setting too high.
2. Applying too much material.
3. Nozzle clogged.
4. Air lter clogged.
5. Too little pressure build-up in
container.
6. Spray material too thick.
1. Decrease material ow setting.
2. Adjust material ow or increase
movement of spray gun.
3. Clean.
4. Change.
5. Tighten container.
6. Thin.
Problem D: Spray jet
pulsates
1. Material in container running out.
2. Air lter clogged.
3. Spray material too thick.
1. Rell.
2. Change.
3. Thin.
Problem E: Too much
overspray
1. Gun too far from spray object. 1. Reduce distance (3”-6” is ideal).
Problem F: Pattern is very
light and splotchy
1. Moving the spray gun too fast.
2. Material ow setting too low.
1. Adjust material ow or de-
crease movement of spray gun.
2. Increase material ow setting.
This unit contains no servicable
electrical parts. Do not attempt to
service yourself. Store indoors with
the cord wrapped around the turbine
handle.
Have you tried the recommendations
above and are still having problems? In
the United States, to speak to a customer
service representative, call our Technical
Service at 1-800-328-8251. See www.
wagnerspraytech.com in the “Contact Us”
section for Technical Service hours.
Uncontrolled Copy