Product Manual

English

Cleanup

Flushing the unit

Before you begin

When cleaning, reference the material manufacturer’s guidelines to

determine the proper cleaning solution and process.

IMPORTANT: Never clean air cap or air holes in the nozzle

withsharpmetalobjects.Donotusesolventsorlubricants

containing silicone.

Special cleanup instructions for use with

flammable solvents:

 • Alwaysushspraygunoutside.

 • Areamustbefreeofammablevapors.

 • Cleaningareamustbewell-ventilated.

 • Donotsubmergeturbine!

Note: All materials need to be properly and completely cleaned

from both the gun and cup prior to using any new spray

materials.

1. Unplug the power cord. Loosen the material container by 1/2

turn, but do not remove it. This will relieve any pressure left

over in the system.

Pull the trigger so that the material inside the spray nozzle

drains back into the container.

2. Unscrew the container and remove. Empty any remaining

material back into the material container.

3. Pour a small amount of the appropriate cleaning solution into

the cup (Warm, soapy water=1/2 full. Mineral spirits=1/4 full).

4. Attach the cup to the nozzle and plug in the sprayer.

5. Spray the cleaning solution into a safe area.

While spraying, gently shake the spray gun. This slight

agitation will help break up smaller particles of spray material.

6. Unplug the power cord. Loosen the material container by 1/2

turn, but do not remove it. This will relieve any pressure left

over in the system.

Pull the trigger so that the material inside the spray nozzle

drains back into the container.

IMPORTANT: If you cleaned the sprayer using mineral

spirits, repeat steps 1-6 using warm, soapy water.

Move on to “Cleanup - Cleaning the Nozzle”, next page.

1/2

PULL

Empty waste

container