Product Manual

English

Assembly

Before you begin

NEVER point the spray gun at

any part of the body.

Note: Your unit includes two nozzle assemblies. See below

to determine the correct nozzle for your spraying project.

 • DetailFinishNozzle

Sprays thinner materials like plastic

coating and some nishing paints

depending on the material. Will

provide a smooth nish.

 • iSprayNozzle-usedforbroad

surface coating. For applying thick

coatings like bed liners and under

coatings. Applies a thick coat with a

textured nish .

Note: These two spray nozzles have dierent spray pattern

/ width controls. Make sure to familiarize yourself with the

controls on each spray nozzle. See the “Controls” section,

page 8-9.

To Assemble

IMPORTANT: Make sure the power cord is unplugged.

1. Insert the suction tube into the intake opening.

2. Align the suction tube -

a. If you are going to be spraying in a downward

direction, the angled end of the suction tube should

be pointing toward the front of the gun.

b. If you are going to be spraying in an upward direction,

the angled end of the suction tube should be pointing

toward the rear of the gun.

Note: Make sure the suction tube is inserted as far as it will

go to ensure a tight t.

3. Carefully screw the cup back onto the spray gun

assembly. Tighten rmly.