Instruction Manual
Page 6
Device Function
Power On Device: Press and hold touch surface for 2 seconds to power on each
ear bud. Ear buds will play an audible “Walker’s” sound clip to indicate the unit has
powered on.
Ambient Volume Adjust: Ambient Volume is controlled by the touch sensor
controls located on the housing of both ear buds.
• Increase Ambient Volume: Swipe Up
• Decrease Ambient Volume: Swipe Down
NOTE:
When Ambient volume reaches minimum there will be a double beep.
When Ambient volume reaches maximum there will be a double beep.
Charging the Ear Buds: To charge your Silencer ear buds, insert them into the included
charging case. When inserted, ear buds will automatically shut down and begin charging.
A red LED will shine to indicate devices are charging. LED will turn blue and then shut o
when earbuds are fully charged.
Note: To pair the Silencer BT 2.0 to a new device, press and hold the power touch surface from an
o state for 7 seconds. This forgets the previously paired device. Silencer BT 2.0 will conrm by
playing a “Pairing” voice clip and the LED with ash red and blue.
Charging the Ear Bud Case: Your charging case will store a charge in order to always be
ready to charge your ear buds. To recharge the battery in the case, plug in a Micro USB
cable, then plug the other end into a USB power source or adapter. Your case will shine
a red LED while charging and your earbuds and case will shine a blue LED and power o
when complete. Charging dock will provide up to 3 full charges.
NOTE: If case has under 10% charge, it will ash a red LED. When user inserts earbuds.
Operation Modes: Earbuds come with four operation modes. Cycle through
operations by double tapping the touch interface on the right earbud.
• Universal: General use with no lter applied
• Clear Voice: Use that emphasizes vocal frequencies
• High Frequency: Amplied higher and vocal frequencies
• Power Boost: Amplied version of Universal