Item #: V42MWF Assembly Instructions For our most current instructions, to request missing, lost or broken parts, or for any other Customer Service issues, please visit our website at www.walkeredison.com or call us at 877-207-5906.
This TV stand can be assembled in three (3) different configurations depending on personal preference. Each configuration is outlined below with the appropriate assembly steps required. Also, each step throughout these assembly instructions includes a small icon of the corresponding configuration for your reference. Configuration 1 - TV Mounted on Stand To build this configuration, follow steps 1 through 12. Configuration 2 - TV Stand Only To build this configuration, follow steps 1 through 5 and step 11.
Parts List
Hardware List Bolt Suction cup pin Bolt Flange bolt Bolt
TV Mounting Hardware List Bolt Bolt Bolt Bolt Bolt Bolt Bolt Bolt Bolt Bolt
Screw cam bolts (1) into legs (A,B). Insert cam locks (2) into front panels (C,D). Attach legs (A,B) to front panels (C,D) using cam bolts as guides. Tighten cam locks (2) with a screwdriver.
Attach crossbars (E,F) to front panels (C,D) using bolts (3) and washers (4). Note that the predrilled holes on the lengths of crossbars (E,F) will face up. Tighten bolts (3) with wrench (12). Attach crossbars (E,F) to lower cable management system (G) using bolts (3) and washers (4). It may be necessary to slightly loosen the bolts from Step 3 in order to align crossbars (E,F) properly. Tighten all bolts (3) with wrench (12).
E F B A E F G Screw suction cup pins (5) into crossbars (E,F). Screw pins (6) into legs (A,B) and lower cable management system (G). Insert rubber pads (9) into legs (A,B). Attach upper cable management system (H) to lower cable management system (G) using bolts (7) and washers (4). Tighten bolts (7) with wrench (12).
Attach pivoting bracket (I) to upper cable management system (H) using bolts (14) and washers (4). Tighten bolts (14) with wrench (12). Attach base bracket (J) to pivoting bracket (I) by inserting bolts (14) with washers (4) through base bracket (J) and pivoting bracket (I) as shown above. Then, screw nuts (8) with washers (4) onto bolts (14). Using wrenches (12,13) together, firmly tighten bolts (14) and nuts (8).
Attach mounting brackets (K) to the TV using the appropriate hardware from the TV mounting hardware kit. Appropriate hardware will vary depending on TV type. Attach tilt adjustment knobs (10) to mounting brackets (K) using flange bolts (11). Two people are recommended for this step! Loosen the adjustment knobs at the base of mounting brackets (K). Carefully hook mounting brackets (K) onto base bracket (J). Tighten the adjustment knobs at the base of mounting brackets (K) to secure the TV to the mount.
Carefully slide glass shelves (M) into place. Carefully place glass shelf (L) on top of the stand and gently push down to secure.