Instructions

Enter main menu (from initial screen).•
Exit from any setting•
Scroll list upwards.•
Increase a numerical value or change a parameter.•
Hold down to display status of channel 1 until button is released•
(under normal operation).
Scroll list downwards.•
Decrease a numerical value or change a parameter.•
Hold down to display status of channel 2 (twin channel models)•
until button is released (under normal operation).
Confirm proposed setting.•
Reset equipment•
Function
Combined keys
Lock / unlock keys ( ).
2 secs.
Temporary manual forcing of channel 1
and 2 (ref. subsection 3-7).
Alternate pressure to change it from
TEMP ON to TEMP OFF.
Note: Reset resets the time switch and is used at first programming, or should
displays of abnormalities or malfunctions be displayed. Press the Reset button
with a pointed object. After a brief display test, all display segments will be lit and
then screen showing the choice of language will be displayed. The following are
lost upon Reset: keyboard blocking, current dateand time settings, these will have
to be re-programmed. The timeswitch will notfunction until you re-program it.Set
programs, external input ON/OFF and data relative to maintenance, operating
hours and warranty counts arenot lost.
1-4 Function keys
1-5 Combined key functions
(NOTE: The programs and external input settings are not deleted).
Permanent manual forcing of channel 1
and 2 (ref. subsection 3-7).
Press for 2 secs. to access PERM
alternate pressure to change it from
PERM ON to PERM OFF.
Return to AUTO mode (if any manual
forcing has been activated).
It is necessary to be on the initial screen to carry out any of the functions (see table)
Connection of single channel and twin channel models
See diagram Fig. 5 on page 17
•
Connecting models with input for DCF77 or GPS
Single channel or twin channel Synchro models with GPS or DCF77 Antenna.
See diagram Fig. 6 on page 17
•
The equipment is supplied without any settings.
Press with a pointed object to unlock the equipment .RESET 1.
Set following data:2.
Languages
• (Ref. subsection 3-8-1).
Date/Time• (Year, Month, Day, Time, Time Zone - ref. subsection 3-8-2).
i
1-6 Connections (disconnect the 230V~ mains voltage)
Maximum cable distance for switch or button connection to external input (E.I.) of
1-7 First switch ON
If there is a power failure, the Date/Time is memorised, and the digital switch:
disables relay(s),•
i
deactivates back-lighting, if active,•
displays flashing date and time for 2 minutes, and then changes to stand-by•
mode (display switched OFF) storing all the programmed data, until the
mains power supply is reconnected or until a button which restarts the
counter for the stand-by mode is pressed for more than 1 sec.
the clock: 100 m (Fig. 5 on page 17).
20
MENu
Ok
Reset
EN
Function
2 secs.
2 secs.
Combined keys
2 secs.
2 secs.
+