Instructions

3-8-3 External input
This enables manual ON and OFF forcing functions to be executed from a remote
position, (ref. section 3.7), by means of buttons or switches.
Function not available for the SYNCHRO models from GPS or DCF77 input
(the "EXT INPUT" item is not available in the "OPTIONS" menu).
Select the "EXT INPUT" sub-menu using keys . 1.
Press to confirm.OK2.
Select switching type (ref. table below) using keys . 5.
Press to confirm.OK6.
In order to deactivate settings made, repeat actions from 1 to 4.
Press to confirm "DEACTIVAT" selection.OK•
Display
Selection
Channel
C1 C2or
(twin channel)
Symbol
Function
External
control
Perm On
off
Switch
of channel ON o OFF.
temp
Temporary forcing of the
channel until the next
switching of a program set
i
i
timer on
off
Forcing of a timed channel
(e.g. stairway lighting
Control).
*Time may be set in format
Hh:mm:ss.
Button
Button
Note: closing of the external input contact is detected immediately by theclock,
while opening cantakemax1sec.
Select the channel with the keys . (dual channel mod.). 3.
Confirm with .OK4.
3-8-4 Maintenance
Allows setting of an operating period in ON for channel C1 and/or C2 (dual channel
mod.). After this period, the clock signals the need for an operation with the writing
"C1 MAINT" or "C2 ", alternating with the current date.MAINT
Select the "MAINTENAN" sub-menu using keys . 1.
C1 flashes.»
Select channel using keys (twin channel models).2.
Press to confirm.OK
3.
Set number of hours using keys .4.
Press to move on to the next channelOK (dual channel only)5.
In order to modify or rest the values, follow
Cancel maintenance notice
i
i
.
Note:
.
if you modify the maintenance count setting, you will lose any partial count
that may havealreadyaccumulated
At the endofthecountdown,theMAINTENANmessageflashesontheactivescreen.
You can cancel the message once you have completed the necessary maintenance
by pressing , pressingandholdingforabout2secondsduringtheactivechannel
warning.
OK
Attention: when you cancel the MAINTENAN message, the maintenance hour
count restarts automatically.
Set the counter to zero for the channel and/or channels to
disable the MAINTENANCE hour count.
This information can be used to perform maintenance at predetermined intervals of
time on theconnectedoutputdevice.
Keep the arrow key pressed to
rapidly increase/decrease the tens, hundreds, etc.
Repeated pressing moves the unit forward one at a
time.
Instructions from 1 to 5.
i
c1
or press to exit.MENU
*Set the time as per previous procedure, entering On and Off.
28
T i m e s e t
previously.
m a i n t e n a n
M a i n t e n a n
Permanent forcing
EN