Instruction manual

LG400 – Operating Instructions
-46-
LG400 Alutec Competition & LG400 Alutec Basic
To set the shaft length, loosen the screws (a). To set the butt plate inclination,
loosen the two screws (b).
To change the position of the butt plate wings individually, loosen the screws (c). If
you remove the two wings, you can attach an MEC butt plate (special accessory) in
their place.
12 Adjusting the cheek piece
LG400 Anatomic & LG400 Alutec Expert
The cheek piece has a wide
variety of possible adjust-
ments, most of which can be
made in the shooting position.
To adjust the cheek piece
height, undo the clamping
screw (a), then alter the
height of the cheek piece
using the setting wheel (b).