Instruction manual

LG400 – Operating Instructions
-47-
The lateral displacement of the cheek piece can also be performed conveniently in
the shooting position using the clamping screw (d). When the latter is undone, the
cheek piece can be pushed towards or away from the face. After adjustment,
retighten the clamping screw (d).
The cheek piece inclination can be altered by undoing the clamping screws (c) and
by rotation about the longitudinal axis, followed by retightening of the clamping
screws (c).
To reposition the cheek piece forwards or rearwards in the longitudinal direction,
remove the countersunk screws (e) and move the sliding blocks in the required
direction. The best way to do this is to remove the complete cheek piece from the
stock (undo screw (a) and remove cheek piece) and the top part of the cheek piece
(undo screw (d) and pull off cheek piece to the side).
Another option for longitudinal adjustment is to move the guide rods; to do so,
remove the countersunk screws (f) and reposition the rail. It is recommended to
leave the guide rods in their block during this assembly process, as this is the only
way to ensure correct alignment.
Tip: The lateral cheek piece contact should if possible be in a straight line with the
barrel axis.
• All functions accessible in the shooting position
• Height adjustment using knurled screw
• Bench rest cheek piece with special rear shape
• Easy setting of height, side and length