Instruction manual

LG400 – Operating Instructions
-49-
Then fix this setting using the screw (a).
Change the height of the grip by undoing the clamping screw (b). Ensure here that
the screw (b) is flush with the flat surface of the grip.
Set the three-dimensional inclination and rotation out of the middle plane of the
grip using the ball-and-socket joint which is fixed by the screw (c). To alter the
setting, undo the screw (c), set the required position of the grip and lock it in this
position by retightening the screw.
Tip: Avoid displacing the grip too far to the side, in order to minimize faults when
the trigger is pulled.
• Optimum grip ergonomics
• 3D-settable
• Interchangeable grip sizes
• Left-hand and right-hand versions
LG400 Alutec BASIC
The basic grip adjustment has the
same possibilities as the expert
grip adjustment, with the
exception of the 3D ball-and-
socket adjustment. To adjust the
grip longitudinally and laterally,
loosen the clamping screw (a). To
adjust the height, loosen the
screw (b).