Instruction manual

LG400 – Operating Instructions
-51-
The standard fore-end elevation can be moved in the longitudinal direction and
adjusted in two steps in the vertical direction. To remove it from the stock, undo
the screws (a). Removing the spacers (b) reduces the height by 10 mm. In this case
the shorter countersunk screw (a), which is supplied as an accessory, must be used
for clamping.
15 Fore-end for shooting from a rest
LG400 Anatomic
The Senior fore-end for bench rest shooting is fastened to the holding rail of the
stock with sliding blocks. Undo the screws (a) and slide the blocks together with
the fore-end onto the rail. Then clamp the fore-end by tightening the screws (a).
The entire fore-end can be swiveled in the transverse direction by undoing the
screws (b).
• Maximum permissible width of bench rest surface
• Infinite lateral swivel in both directions
• Easy to fit and to remove
• Resting point near the muzzle
LG400 Alutec (Basic & Expert)
The model Alutec, which has an aluminum stock, can be converted into an air rifle
for DSB bench rest shooting by fitting it with a stock extension and a Senior fore-
end.