Instruction manual

LG400 – Operating Instructions
-52-
For this purpose, first remove the fore-end for shooting in the standing position
and pre-mount the Senior fore-end (g) and the stock extension (f) as shown below.
• Insert the strip (e) into the T-groove of the stock extension (f) and center it at
the back edge of the stock extension (f). Tighten both clamping screws (d).
• Push the stock extension (f) over the T-groove onto the sliding block of the
Senior fore-end (g).
• Then push the Senior fore-end (g) together with the stock extension (f) onto
the stock of the air rifle. In doing so, make sure that the sliding blocks (c) and
the strip (e) come to rest in the T-groove of the stock.
• Press the stock extension (f) onto the stock of the air rifle and secure it in place
with the clamping screws (e).
• Move the Senior fore-end (g) into the correct position and tighten it with the
three clamping screws (a).
Follow the same procedure to attach the Senior fore-end with Expert double joint.