Nailed Down Hardwood Installation

TempZone Flexroll Hardwood

Installation Overview

STEP 1: Install Wood Sleepers

Install wood sleepers (strips of wood 1" to 2" wide and 3/8" to

1/2" high) at nail spacing requirements speciﬁed by the

manufacturer. The sleepers are installed to create lanes into

which the warming system will be placed. The ﬂooring should

be installed as per the ﬂooring manufacturer's requirements.

Verify with the manufacturer that the ﬂooring has been

approved for this use. Supply WarmlyYours with nail spacing

parameters and the Smartplan will be drawn accordingly.

STEP 2: Lay The Heating System

Cut and turn the rolls to ﬁt into the lanes created by the

sleepers.

STEP 3: Cover Rolls With Self Leveling Cement

Once the system is in place, the warming roll should be

covered with self leveling cement up to and even with the top

of the wood sleepers.

STEP 4: Install Hardwood Flooring

Once the self leveling cement has dried and cured to the

manufacturer's speciﬁcations the hardwood ﬂoor can be

installed by nailing it into the wood sleepers. Be careful not to

place nails or staples near the heating cable or power leads.

Follow These Steps When Installing a System Under

Hardwood Floor Covering