Installation Guide

STEP 8: Insert long screw (h) through

mounting bracket (g), then screw into plastic

drywall anchor (f).

Note: the two larger brackets are designed to be

used to secure the mounting shelf. The smallest

bracket should be used to secure one of the

mounting tubes, while the other is secured by the

power-source faceplate with mounting bracket.

STEP 8

STEP 9: Install the tube (a and b) onto the

bracket (g).

STEP 9

STEP 10: As shown in the picture, install the

set screws (c) into the hole of all the tubes (a,b

and k) using the allen wrench; fix the tube (a,b

and k) onto the mounting bracket (g).

STEP 10

Installation Support •(800) 875-5285 • WarmlyYours

INSTALLATION GUIDE

For TWS1-HRN08 hardwired towel warmers

STEP 5: Use a tape measure to measure the distance

between the center points of each wall bracket tube;

record the distances between points AB, AC, CD, and

BD. Mounting point C will determine electrical box

location. See Electrical Assembly in following

instructions.

STEP 5

STEP 6: Mark A, B, C, and D according to the data from

Step 5; It is suggested that this product be installed at

least 23.5 inches (59.69 cm) above floor level.

(WARNING: The electrical connection should avoid all

water). This mounting location must comply with all local

building and electrical codes.

Place towel warmer on the box (or a large sheet of paper)

and lay on a flat surface with mounting tubes facing

downwards. Mark the location of the following:

• The electrical collar (hardwired model only)

• The location of the mounting tubes

Use the template as a guide to mark the wall with the correct

locations of the four mounting tubes (A, B, C, and D)

STEP 6

STEP 7: Drill A, B, C, and D holes with an

appropriately sized bit. Use a hammer to knock

plastic drywall anchor (f) into wall completely.

STEP 7

ALTERNATIVE TO STEPS 5 & 6