Operating instructions

QUICK START PREAMP

GETTING STARTED

1. Make sure that the Power Amplifier load is matched to the connected loudspeakers load.

We recommend using speaker cables with lockable coaxial connectors that meet a cross-section of at least 2 x 1.5 mm.

2. Check that the mains supply has been plugged in and that the connection Pre- to Power- Amplifier is correct.

3. Make sure that external (effects) units possibly used are correctly connected and operational.

4. Set the MASTER controls (Pre- and Power Amplifier) to zero.

5. Plug your bass guitar into the Preamp's INPUT with a shielded line-cable.

6. Press the POWER switch to turn on the units.

7. Switch MUTE off and the red LED will extinguish.

8. Turn all volume controls of your bass guitar on to their maximum.

9. Adjust the GAIN control until the CLIP LED flashes green (Note PAD -20dB switch). The clip LED turning red indicates clipping

10. Set the LEVEL on the Power Amplifier to 5 and slowly increase the MASTER volume to a pleasing level.

11. Dial in the sound you want using the controls, described in their respective chapters.

12. If necessary readjust GAIN setting. Green indicates correct operating level, red indicates distorted signal.