Operating instructions

SoftCare Evo - Type SE10 9-9
Chapter 9 - Operating units
9.3. Starting up the operating terminal
The operating terminal is started automatically when
the roll-over car wash system is switched on at the
main switch.
Depending on the operation mode, the display may
show one of the messages below:
Drive in vehicle
or
Select program or Please insert card
9.4. Starting wash programs
Wash programs may be started by entering a pro-
gram number or a program code (code operation
mode).
In Code operation mode the customer receives at
purchase a ticket with an access code. The wash
procedure is started by entering the access code at
the operating terminal.
Please note that in code operation mode the pro-
gram selection has to be switched-off (see menu
0361 in chapter 9.6). Otherwise the operating
terminal takes the data entry as a program num-
ber.
NOTICE