Operating instructions

SoftCare Evo - Type SE10 9-16
Operating terminal CP1
Operating terminal CP0
Chapter 9 - Operating units
9.6. Service programs
Service programs allow the manager or owner of the
wash tunnel to modify designated settings of the sys-
tem.
Service programs are started by using the special
function button <<P>>.
At the operating terminal CP 1 you can start the ser-
vice program directly by pressing the button <<P>>.
At the operating terminal CP0 you probably have to
shift the symbol “P” into the display by using the
navigation buttons. Afterwards you may start the ser-
vice with one of the selection buttons, e.g. F4.
During the further description of the service pro-
grams the keypad of the operating terminal is shown
occasionally. The illustration shows always the key-
pad of the operating terminal CP1. Inputs at the op-
erating terminal CP0 should be done in a similar
way.