Operating instructions
SoftCare Evo - Type SE10 10-9
Structure
Operation modes
Off
Close before drying
Close before washing
Chapter 10 - Special equipment
10.5. Rolling shutter door control
Rolling shutter doors which are already fitted in the
building can be controlled conveniently with the roll-
ing shutter door controls.
The rolling shutter doors are controlled by the con-
troller of the wash system. The settings can be done
in the service program (see chapter 9.1.5 menu 033
door functions). In drive-through halls each door can
be individually set, e.g. entrance door =close before
drying and exit door = winter operation mode. In
halls with one door (entrance door = exit door) both
doors must be set to the same operation mode.
The rolling shutter door controller can be operated in
4 operation modes:
The rolling shutter doors are not actuated. The doors
can only be operated with the buttons provided by
the door supplier.
⇒ Entrance and exit door close before the drying
procedure starts.
⇒ Entrance and exit door open after the drying
procedure is finished or with end of the wash
program.
⇒ Entrance and exit door close before start of
the wash program.
⇒ Entrance and exit door open with end of the
wash program.