Operating instructions

SoftCare Evo - Type SE10 5-3

Information only for

the operator

Information only for

the operator

Chapter 5 - Washing operation

WashTec can accept no responsibility for dam-

age to vehicles where one or more of the points

listed above are applicable. If these vehicles are

washed irrespective of the above points, this

must be done on the good judgement of the op-

erator and will be his responsibility.

The following points must be observed here in

particular:

Special attachments or mounted elements which

cannot be removed must be overridden manually

with the relevant control buttons on the operating

unit (see Chapter 9 "Operating units").

For vehicles with wheel claddings and vehicles

with low or high ground clearance, the wheel

washer must be controlled manually (see Chap-

ter 9 "Operating units").

For vehicles with a low ground clearance, there

is a risk that the vehicle will get stuck if a non-

recessed under-body wash or car shifting device

is installed.

For pick-ups, i.e. vehicles with an open loading

area, and vehicles with unfavourable designed

rear spoilers the roof brush has to be manually

controlled.

For wash systems which are operated in self-

service mode, e.g. the operator or his personnel

are not present during the wash cycle, it is highly

recommended to install a video surveillance for

inspecting every vehicle before the vehicle is

cleaned.

The operating units offer various possibilities for

starting the wash program and controlling it

manually.

NOTICE