Operating instructions

SoftCare Evo - Type SE10 5-5
Operation mode 1
Chapter 5 - Washing operation
5.3. Car wash procedure
The car wash procedure depends on the selected
start setting (see chapter 9.6. menu 035 Automatic
start), on the setting of the entrance/exit doors (see
chapter 9.6. menu 033 door functions) and whether
the driver remains in the vehicle during the wash cy-
cle or waits outside of the wash building.
Three typical car wash procedures are described
below.
Automatic start is switched off, the entrance door is
open and the driver waits outside of the wash build-
ing.
)
Drive the vehicle forward into the wash system
so that there is enough space on each side.
)
Position the vehicle correctly
⇒ The traffic light shows “Stop”.
)
Turn off the engine, put the car in PARK (for a
standard car put the car in 1st gear) and apply
the parking brake.
)
Close the windows, leave the vehicle and lock
all vehicle doors (including trunk or tailgate).
)
Leave the car wash building.
)
Select a wash program (by card or by input at
the operating unit).
⇒ The wash program will be started automati-
cally.
⇒ When the wash cycle is finished, the roll-over
car wash system returns to its home position.
⇒ The traffic light shows the drive-out direction.
)
Enter the vehicle and drive the car out of the
wash building.