Operating instructions

SoftCare Evo - Type SE10 6-1

Main pressure

1 = Compressed air inlet

2 = Compressed air outlet

3 = Regulator knob

4 = Condensation

container

6 = Drain valve

7 = Ball valve

Fig. 6-1: Filter pressure regula-

tor

Chapter 6 – Settings and checking

6. Settings and checking

Adjustments at a system which is switched on

may cause serious accidents.

Pay unconditional attention to the safety instruc-

tions in chapter 2.

6.1. Adjusting the compressed air

The filter pressure regulator cleans the compressed

air from destructive particles and regulates the main

pressure.

Set-value main pressure: approx. 6 bar.

The ball valve (7) is used to control the supply of

compressed air. Always close the ball valve to sepa-

rate the system from the existing compressed air

supply (e.g. for maintenance work).

The compressed air is adjusted at the regulator

knob (3).

)

Release the regulator by pulling up the regula-

tor knob.

)

Set the required pressure by turning the regu-

lator knob to the right or left. The adjustment

range is between 0.6 and 10 bars.

)

Secure the regulator by pushing the regulator

knob back down again.

The compressed air may contain condensation water

which settles in the condensation container (4). The

draining is carried out automatically by the drain

valve (6).

Only oil-free compressed air is permitted.

In most countries mandatory.

NOTICE