Instruction Manual

Controller display is ashing “EE”

• The controller has a data or memory failure

The refrigerated cabinet isn’t running

• Is there electrical power to the unit?

• Is your home circuit breaker or fuse on?

• Is your ON/OFF key pad on?

• Is your condenser area clean?

The refrigerated compartment is warmer than usual

• Is your control set properly?

• Is the light staying on?

• Is your condenser area clean and free of obstructions?

• Has the door been open for a long time or more frequent door openings occurred?

• Are the internal louvers and fan guard openings obstructed?

• Has warm product just been placed in the cabinet?

The refrigerated compartment is colder than usual

• Is your control set properly?

• Is your door closing and sealing properly?

• Is the ambient temperature within the normal operating range?

The refrigeration system runs for long periods of time

• Is the condenser area clean and free of obstructions?

• Have the doors been open for a long time or more frequent door openings occurred?

• Have warm product just been placed in the cabinet?

• On hot days and in warm room temperatures the system will run long.

Condensation forms inside the refrigerated compartments

• This is normal during high humidity and frequent door openings.

• Are the doors closing and sealing properly?

Condensation forms on the outside of the unit

• During periods of high humidity some condensation might appear on outside surfaces. The conden-

sation will disappear when the humidity drops. Meanwhile, be sure doors are closing and sealing properly. If

condensation persists, contact your Perlick Factory Authorized Service Center.

You need product information

• Contact your selling dealer

• Inquire via the WEB at www.perlick.com

• Call 800/558-5592for factory assistance for information for planning, installation or

product information.

• Write to: Perlick Corporation, Customer Service Department, 8300 W. Good Hope Rd,

Milwaukee, WI 53223

• or e-mail us at warrantyserv@perlick.com.

You need product service

• Check the model and serial number of your unit located on the label attached to the inside top of

the cabinet. Then call your Perlick Factory Authorized Service Center. For the location of the Service Center

in your area, contact your dealer, inquire via the WEB at www.perlick.com, or write to: Perlick Corporation,

Document No. Z2305