User guide

ManualsBrandsWater Inc ManualsWater boilerLVH 1310

LVH 500 / 510 / 610 / 630 / 720

1000 / 1120 / 1200 / 1310

READ ALL INSTRUCTIONS COMPLETELY BEFORE PROCEEDING WITH

INSTALLATION. INCORRECT INSTALLATION VOIDS THE WARRANTY.

INSTALLATION INSTRUCTIONS: PLEASE LEAVE WITH THE HOMEOWNER

If service is required, rst disconnect power cord and shut off water supply to the EvErHot.

Then call Water, Inc. Service Department at 1-800-322-9283 ext.112 or 115 [Local 310-885-4400 ext.112 or 115].

Removal of the EvErHot without approval may VOID the warranty.

ELECTRICAL REQUIREMENTS:

INSTALLATION WARNINGS:

DO NOT, UNDER ANY CIRCUMSTANCES,

REMOVE THE POWER SUPPLY CORD GROUNDING PRONG!!

For your safety, this appliance must be grounded.

This appliance must be plugged into a mating 3 prong grounding type wall receptacle.

A 15 or 20 Amp circuit is acceptable. This unit requires a constant power supply. It must not be plugged

into the same outlet as the garbage disposal. Water, Inc. offers a dual-plug Air Switch, which is a great

solution for operating an EverHot and garbage disposal. Call our ofce for details. If a properly

grounded outlet is not available, it is the personal responsibility of the customer to have one installed by

a licensed electrician. Outlet must be available in cabinet containing the EvErHot heating tank.

WARNING: An extension cord is not recommended for use with this appliance.

Such use may result in re, electric shock or other personal injury.

NOTE: Warranty DOES NOT COVER problems due to improper installation.

CAUTION: Plumbing connections must comply with all sanitary, safety and local plumbing codes.

Do not remove clear plastic tube from inside the faucet spout.

CAUTION: HEATING TANK MUST BE FILLED WITH WATER and the

thermostat turned to the off position before electrical power is connected.

FAILURE TO DO SO WILL CAUSE PERMANENT DAMAGE TO THE UNIT.

Damage to the unit due to “dry start” is NOT covered under the Warranty.

CAUTION: Do not use pipe sealing compounds. These compounds will cause an

unpleasant taste or odor to the water. These compounds are not needed with the

special ENCLOSED ttings used with this product.

EverHot mark is used under license from Bradford White Corp. • Body Glove is a registered trademark of Body Glove International, LLC. • Teon is a registered trademark of E.I. Dupont de Nemours & CO. Willmington, DE 19898 U.S.A.

SAVE THESE INSTALLATION INSTRUCTIONS

AND LEAVE WITH THE HOMEOWNER.

Please make sure you review #13 (After-Installation EverHot Tips on page 3)

to ensure proper long-term care of your new EverHot system.

* *

* These faucets also use supplemental installation instructions along with this booklet.

The red circled numbers (ex: ) relate to the supplemental instructions.

800-322-9283 • waterinc.com

M - F 8 AM - 5 PM (PST)

ater

Inc

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS: PLEASE LEAVE WITH THE HOMEOWNER LVH 500 / 510 / 610 / 630 / 720* 1000 / 1120* / 1200* / 1310 * These faucets also use supplemental installation instructions along with this booklet. The red circled numbers (ex: 3 ) relate to the supplemental instructions. READ ALL INSTRUCTIONS COMPLETELY BEFORE PROCEEDING WITH INSTALLATION. INCORRECT INSTALLATION VOIDS THE WARRANTY. If service is required, first disconnect power cord and shut off water supply to the EverHot.
PAGE 2
PARTS LIST 1-USERS’ GUIDE AND WARRANTY INFORMATION SHEET 1- EverHot Faucet with bag containing: Escutcheon, Vinyl Gasket & Flat Metal Washer (Fig. 1) - or - C-Shaped Metal Washer (Fig. 1A), Spacer, Lock Washer, Nut, and Mounting Nut Wrench.
PAGE 3
FIG. 2 The ease and simplicity of using enclosed fittings. Collets and O-rings are readily replaceable - a useful feature in cases of misuse or accidental damage. DO NOT USE A TUBE INSERT WITH THESE FITTINGS. Simply push-in-tube to attach Tube is secured in position. Push in and hold collet while gently pulling tube to release. Note: Tube must be cut squarely and pushed straight in. 8. Connect the blue tube that originates beneath the cold handle to the cold water supply.
PAGE 4
EVERHOT INSTALLATION SCHEMATIC HOT WATER LEVER ADDITIONAL 1/4” O.D. TUBING AND FITTINGS MAY BE REQUIRED LEAVE SPACE FOR AIR CIRCULATION AROUND CHILLER (ALL SIDES) WATER CHILLER OUTLET BLUE PLASTIC TUBE* TO WATER SUPPLY RECOMMEND INSULATING CHILLED WATER SUPPLY LINE NOTE: IF WATER CHILLER IS NOT USED, INCOMING COLD WATER GOES FROM FILTER DIRECT TO EverHot FAUCET (BLUE TUBE) OTHER WATER USING APPLIANCES LIKE ICE MAKERS, COFFEE MAKERS, ETC.