User guide

EVERHOT
INSTALLATION SCHEMATIC
WATER FILTRATION SYSTEM:
BODY GLOVE™ ANY MODEL
DO NOT KINK TEFLON TUBING
IMPORTANT:
(NOT DRAWN TO SCALE)
800-322-9283 • waterinc.com
* USE ONLY DELRIN (PLASTIC) FERRULE OR PUSH-TO-CONNECT FITTING ON PLASTIC TUBE. DO NOT USE BRASS FERRULE ON PLASTIC TUBE AS LEAK OR FLOODING MAY RESULT. DO NOT USE A TUBE INSERT.
** IF CLEAR PLASTIC TUBE IS PULLED OUT OF FAUCET BODY EVEN PARTIALLY, DAMAGE WILL OCCUR CAUSING WATER LEAK. PLEASE NOTE THAT DAMAGE TO UNIT IS NOT COVERED UNDER PRODUCT WARRANTY.
ADDITIONAL 1/4” O.D. TUBING
AND FITTINGS MAY BE REQUIRED
THE WATER SUPPLY FOR THE ENTIRE SYSTEM IS FROM THIS COLD WATER RISER
OTHER WATER USING APPLIANCES LIKE
ICE MAKERS, COFFEE MAKERS, ETC.
CONNECT TO THIS LINE BY USING
1/4” TEE(S)
NOTE: IF WATER CHILLER
IS NOT USED, INCOMING
COLD WATER GOES FROM FILTER
DIRECT TO EvErHot FAUCET
(BLUE TUBE)
RECOMMEND INSULATING
CHILLED WATER SUPPLY LINE
HOT WATER LEVER
COLD WATER LEVER
WATER CHILLER OUTLET
BLUE PLASTIC TUBE* TO WATER SUPPLY
RED PLASTIC TUBE* TO 1/4 INTEGRAL FITTING ON TANK
TEFLON (CLEAR PLASTIC) TUBE** TO STAINLESS STEEL TANK TOP CENTER TUBE USING REDUCTION FITTING (PROVIDED)
OFF/ON THERMOSTAT CONTROL KNOB
LEAVE SPACE FOR AIR CIRCULATION AROUND CHILLER (ALL SIDES)
WATER CHILLER INLET
2” REQUIRED BETWEEN BOTTOM OF FILTRATION CARTRIDGE AND CABINET FLOOR FOR CARTRIDGE CHANGE
3 PRONG
GROUNDING TYPE
WALL RECEPTACLE
REQUIRED.
FILTER INLET
FILTER OUTLET
W-192 (Rev. 7/2014)
3/8”X 5/16” REDUCING UNION
PROVIDED WITH THE EVERHOT
Water Inc
page 4
CHILLER:
EVERCOLD
®
WIC-400S OPTIONAL
(NOT INCLUDED WITH EVERHOT)
INSTANT HOT:
EvErHot tank
(LVH-500 FAUCET PICTURED ABOVE)
(your tank may be a different shape)