WHEEL PULLDOWN FAUCET INSTALLATION INSTRUCTIONS Model #: 5100 5100
INSTALLATION GUIDE BEFORE YOU BEGIN YOUR INSTALLATION: 1 2 Turn off water supply. 3 Observe all local plumbing codes. 4 Inspect waste and water supplies for signs of damage. Replace as necessary. REQUIRED TOOLS: DO NOT use petroleum based products on this faucet. PARTS INCLUDED: *XX represents finish HK-THC-XX* TRADITIONAL HANDLE BUTTON KIT 1. Adjustable Wrench 2.
WHEEL FAUCET INSTALLATION 1. 2. 3. 4. C COUNTER OR SINK E D B G A Remove the clamp nut (A) and washer (B) from the threaded C D E F shroud (C). B Fit flexible hoses (D) through hole on counter or sink. (No plumbers putty is required. O-ring seals base). Slide washer and thread the clamp nut ontoFACTORY threaded shroud. ORIGINAL POSITION TightenMAY nut HIT snugBACKSPLASH to underside of sink or counter. Turn faucet to thePOSITION desired handle NEW ADJUSTED position.
CONNECTING SUPPLY HOSES ADJUST HANDLE POSITION AND HANDLE TENSION On some kitchen countertops, the handle may hit the backsplash when the faucet handle is positioned to the left or right (Fig. 1). Waterstone gives you the option of adjusting the handle 45 degrees to avoid hitting backsplash. A B 1. Before connecting supply hoses, flush supply stops to clear any debris. Place a bucket underneath stops and run water for 5 to 10 seconds. Turn water off. 2.