Owner manual

Watlow EZ-ZONE
®
PM Integrated Controller • 112 • Chapter 7 Profiling Page
Display Step Type
Description
Parameters in Step Type
[`End]
[ End]
Step Types
End
An End Step will end the profile and set the control modes
and set points to match the End Type. The state of up to 2
event outputs may be set or maintained. The event outputs
will not be set off unless specifically stated in this step. If a
profile does not have an End Step, the profile continues until
step 40, then stops and maintains the last set points and
control modes.
[`End] End Type
[Ent1] Event 1
[Ent2] Event 2