Owner manual
Watlow EZ-ZONE
®
PM Integrated Controller • 161 • Chapter11Appendix
As can be seen on the previous page the PM Implicit Assembly defaults (factory settings) to a populated as-
sembly structure. If it is desired to modify any of the given assembly members there are many software tools
available to do so. It is outside of the scope of this document to describe how to use those. What can be found
in this document is the process to build the assembly structure. If viewing this document electronically sim-
ply click on the link below to read the section entitled " Modifying Implicit Assembly Members". Otherwise,
turn back to the table of contents to find the above named section.
Compact Class Assembly Structure
On the next four pages, the 17 available members of the Compact Class are displayed. As an orientation to
the format as displayed in this document, notice that each member begins with header identified as "Assem-
bly" and below the header you will see the member number along with param-
eter information contained within. While looking at these illustrations keep in
mind that each member is actually 32-bits in length. To better illustrate this
information in this document, the following 6 pages present these members
divided in half where the letter "A" in the page header and assembly number
represents the most significant 16-bits where the letter "B" in the title and as-
sembly number represents the least significant 16-bits of each member. In the event that these pages are
printed out and then mixed up, simply match up the page headers placing them side by side. As an example,
Compact Class 1 A through 7 A should be paired with Class 1 B through 7 B, left to right.
For further explanation as to what the Compact Class assembly is, navigate to the section entitled "Compact
Assembly Class"