Owner manual
Watlow EZ-ZONE
®
PM Integrated Controller • 68 • Chapter 6 Setup Page
[LiM]
[`Set] Limit Menu
[`L;SD] Limit Sides
[`L;hy] Limit Hysteresis
[SP;Lh] Set Point High Limit
[SP;LL] Set Point Low Limit
[`Lh;S] Limit High Set Point **
[`LL;S] Limit Low Set Point **
[SFn;A] Source Function A **
[`Si;A] Source Instance A **
[`l;Cr] Limit Clear Request **
[`l;st] Limit Status **
[`l;it] Integrate with System
[Loop]
[`Set] Control Loop Menu
[```1]
[Loop] Control Loop (1 to 2)
[`h;Ag] Heat Algorithm
[`C;Ag] Cool Algorithm
[`C;Cr] Cool Output Curve
[`h;Pb] Heat Proportional Band
[`h;hy] Heat Hysteresis
[`C;Pb] Cool Proportional Band
[`C;hy] Cool Hysteresis
[``ti] Time Integral
[``td] Time Derivative
[``db] Dead Band
[t;tUn] TRU-TUNE+ Enable
[t;bnd] TRU-TUNE+ Band
[`t;gn] TRU-TUNE+ Gain
[A;tSP] Autotune Set Point
[t;Agr] Autotune Aggressiveness
[`P;dl] Peltier Delay
[`r;En] Remote Set Point Enable
[`r;ty] Remote Set Point Type
[`UFA] User Failure Action
[FAiL] Input Error Failure
[MAn] Fixed Power
[`L;dE] Open Loop Detect Enable
[`L;dt] Open Loop Detect Time
[`L;dd] Open Loop Detect Deviation
[``rp] Ramp Action
[`r;SC] Ramp Scale
[`r;rt] Ramp Rate
[`L;SP] Low Set Point
[`h;SP] High Set Point
[`C;SP] Closed Loop Set Point
[`id;S] Idle Set Point
[SP;Lo] Set Point Open Limit Low
[SP;hi] Set Point Open Limit High
[`o;SP] Open Loop Set Point
[`C;M] Control Mode
[otpt]
[`Set] Output Menu
[```1]
[otpt] Output (1 to 4)
[``Fn] Output Function
[``Fi] Output Function Instance
[`o;Ct] Output Control
[`o;tb] Output Time Base
[`o;Lo] Output Low Power Scale
[`o;hi] Output High Power Scale
[otpt] Output Process (1, 3)
[`o;ty] Output Type
[``Fn] Output Function
[`r;sr] Retransmit Source
[``Fi] Output Function Instance
[`S;Lo] Scale Low
[`S;hi] Scale High
[`r;Lo] Range Low
[`r;hi] Range High
[`o;lo] Output Low Power Scale
[`o;ho] Output High Power Scale
[`o;CA] Calibration Offset
[ALM]
[`Set] Alarm Menu
[```1]
[ALM] Alarm (1 to 4)
[`A;ty] Alarm Type
[`sr;a] Alarm Source
[`is;;A] Alarm Source Instance
[loop] Control Loop
[`A;hy] Alarm Hysteresis
[`a;Lg] Alarm Logic
[`A;SD] Alarm Sides
[`A;Lo] Alarm Low Set Point
[`A;hi] Alarm High Set Point
[`a;LA] Alarm Latching
[`A;bL] Alarm Blocking
[`a;Si] Alarm Silencing
[A;dsp] Alarm Display
[`A;dL] Alarm Delay Time
[a;Clr] Alarm Clear Request
[a;sir] Alarm Silence Request
[`a;st] Alarm State
[CUrr]
[`Set] Current Menu
[`C;Sd] Current Sides
[`C;Ur] Current Read Enable
[`C;dt] Current Detection
Threshold
[`C;SC] Input Current Scaling
[C;ofs] Heater Current Offset
[`C;Si] Current Output Source
Instance
[MAt]
[`Set] Math Menu
[``Fn] Function
[SFn;E] Source Function E
[`Si;E] Source Instance E
[`S;Lo] Scale Low
[`S;hi] Scale High
[`r;Lo] Range Low
[`r;hi] Range High
[`FiL] Filter
[`SoF]
[`Set] Special Output Function Menu
[``Fn] Function
[SFn;A] Source Function A
[`Si;A] Source Instance A
[SFn;B] Source Function B
[`Si;B] Source Instance B
[Pon;A] Power On Level 1
[PoF;A] Power Off Level 1
[Pon;b] Power On Level 2
[PoF;b] Power Off Level 2
[`on;t] On Time
[`of;t] Off Time
[``t;t] Valve Travel Time
[``db] Dead Band
[`t;dl] Time Delay
[`fUn]
[`Set] Function Key Menu
[```1]
[`fUn] Function Key (1 to 2)
[`leu] Active Level
[``Fn] Action Function
[``fi] Function Instance
[gLbL]
[`Set] Global Menu
[`C_F] Display Units
[AC;LF] AC Line Frequency
[r;typ] Ramping Type
[p;typ] Profile Type
[`gse] Guaranteed Soak Enable
[gsd1] Guaranteed Soak Devia-
tion 1
[gsd2] Guaranteed Soak Devia-
tion 2
[`si;a] Source Instance A
[`si;b] Source Instance B
[poti] Power Off Time
[sutb] Synchronized Variable
Time Base
[C;led] Communications LED Act-
ion
[2one] Zone
[Chan] Channel
[d;prs] Display Pairs
[`d;ti] Display Time
[Usr;s] User Settings Save
[Usr;r] User Settings Restore
[COM]
[`Set] Communications Menu
[```1]
[COM] Communications (1 to 2)
[pCol] Protocol
[`a;ds] Standard Bus Address
[bAUd] Baud Rate
[`PAr] Parity
[M;hL] Modbus Word Order
[iP;m] IP Address Mode
[ip;f1] IP Fixed Address Part 1
[ip;f2] IP Fixed Address Part 2
[ip;f3] IP Fixed Address Part 3
[ip;f4] IP Fixed Address Part 4
[ip;f5] IP Fixed Address Part 5
[ip;f6] IP Fixed Address Part 6
[ip;51] IP Fixed Subnet Part 1
[ip;52] IP Fixed Subnet Part 2
[ip;53] IP Fixed Subnet Part 3
[ip;54] IP Fixed Subnet Part 4
[ip;s5] IP Fixed Subnet Part 5
[ip;s6] IP Fixed Subnet Part 6
[ip;g1] IP Fixed Gateway Part 1
[ip;g2] IP Fixed Gateway Part 2
[ip;g3] IP Fixed Gateway Part 3
[ip;g4] IP Fixed Gateway Part 4
[ip;g5] IP Fixed Gateway Part 5
[ip;g6] IP Fixed Gateway Part 6
[mb;e] Modbus TCP Enable
[eip;e] EtherNet/IP Enable
[ao;nb] CIP Implicit Assembly
Output Member Quantity
[ai;nb] CIP Implicit Assembly In-
put Member Quantity
[`C_f] Display Units
[map] Data Map
[`nu;s] Non-Volatile Save
[`rtC]
[`Set] Real Time Clock
[hoUr] Hours
[min] Minutes
[dow] Day of Week