User guide

Watlow EZ-ZONE
®
PM PID Controller • 46 • Chapter 6 Setup Page
[`o;Lo] Output Low Power Scale
[`o;hi] Output High Power Scale
[otpt] Output 1 process
[`o;ty] Output Type
[``Fn] Output Function
[``Fi] Output Function Instance
[`S;Lo] Scale Low
[`S;hi] Scale High
[`r;Lo] Range Low
[`r;hi] Range High
[`o;lo] Output Low Power Scale
[`o;ho] Output High Power Scale
[`o;CA] Calibration Offset
[ALM]
[`Set] Alarm Menu
[```1]
[ALM] Alarm (1 to 4)
[`A;ty] Alarm Type
[`sr;a] Alarm Source
[`A;hy] Alarm Hysteresis
[`a;Lg] Alarm Logic
[`A;SD] Alarm Sides
[`A;Lo] Alarm Low Set Point **
[`A;hi] Alarm High Set Point **
[`a;LA] Alarm Latching
[`A;bL] Alarm Blocking
[`a;Si] Alarm Silencing
[A;dsp] Alarm Display
[`A;dL] Alarm Delay Time
[a;Clr] Alarm Clear Request
[a;sir] Alarm Silence Request
[`a;st] Alarm State
[`fUn]
[`Set] Function Key Menu
[```1]
[`fUn] Function Key (1 to 2)
[`leu] Level
[``Fn] Action Function
[``fi] Function Instance
[gLbL]
[`Set] Global Menu
[`C_F] Display Units
[AC;LF] AC Line Frequency
[r;typ] Ramping Type
[p;typ] Profile Type
[`gse] Guaranteed Soak Enable
[gsd1] Guaranteed Soak Deviation 1
[`si;a] Source Instance A
[`si;b] Source Instance B
[poti] Power Off Time
[subt] Synchronized Variable Time Base
[C;led] Communications LED Action
[2one] Zone
[Chan] Channel
[d;prs] Display Pairs
[`d;ti] Display Time
[Usr;s] User Settings Save
[Usr;r] User Settings Restore
[COM]
[`Set] Communications Menu
[pCol] Protocol
[`a;ds] Standard Bus Address
[ad;m] Modbus Address
[bAUd] Baud Rate
[`PAr] Parity
[M;hL] Modbus Word Order
[`C_f] Display Units
[map] Data Map
[`nu;s] Non-Volatile Save
[`rtC]*
[`Set] Real Time Clock Menu
[hoUr] Hours
[min] Minutes
[dow] Day of Week
* Available with PM4, PM8 and PM9 models only
** These parameters/prompts are available with firmware revisions 11.0 and above.