User guide

Watlow EZ-ZONE
®
PM PID Controller • 78 • Chapter 8 Factory Page
To go to the Factory Page from the Home Page, press and hold both the Advance
‰
and Infinity ˆ keys for
six seconds.
• Press the Advance Key
‰
to enter the menu of choice.
• Ifasubmenuexists(morethanoneinstance),presstheUp¿ or Down ¯ key to select and then press the
Advance Key
‰
to enter.
• PresstheUp¿ or Down ¯ key to move through available menu prompts.
• PresstheInfinityKeyˆ to move backwards through the levels: parameter to submenu; submenu to menu;
menu to Home Page.
• PressandholdtheInfinityKeyˆ for two seconds to return to the Home Page.
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See model
number infor mation in the Appendix for more information. If there is only one instance of a menu, no sub-
menus will appear.
Chapter 8: Factory Page
Navigating the Factory Page
8
[CUSt]
[FCty] Custom Setup Menu
[```1]
[CUSt] Custom Setup (1 to 20)
[`par] Parameter
[`iid] Instance ID
[`LoC]
[FCty] Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[LoC;P] Profiling Page
[pas;e] Password Enable
[RloC] Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
[ULoC]
[FCty] Security Setting Menu
[Code] Public Key
[Pass] Password
[diAg]
[FCty] Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[`CAL]
[FCty] Calibration Menu
[```1]
[`Cal] Calibration (1 to 2)
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELo;s] Electrical Output Slope
[``Pn] Part Number
[Code] Code