User guide

Watlow EZ-ZONE
®
PM PID Controller • 79 • Chapter 8 Factory Page
Factory Page
Dis-
play
Parameter Name
Description
Range Default
Modbus
Relative Ad-
dress
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Param-
eter ID
Data
Type
&
Read/
Write
[Cust]
[fcty]
Custom Menu
[`par]
[ Par]
Custom
Parameter 1 to 20
Select the parameters that
will appear in the Home
Page.
The Parameter 1 value will
appear in the upper dis-
play of the Home Page. It
cannot be changed with
the Up and Down Keys
in the Home Page.
The Parameter 2 value will
appear in the lower dis-
play in the Home Page. It
can be changed with the
Up and Down Keys, if the
parameter is a writable
one.
Scroll through the other
Home Page parameters
with the Advance Key
‰
.
Note:
Display Pairs affect the
pairing of custom pa-
rameters on the Home
page. For more informa-
tion on Display Pairs see
the section in this guide
entitled "Modifying the
Display Pairs"
[nonE] None
[`Pro] Process
[`i;CA] Calibration Offset
[`C_F] Display Units
[USr;r] User Settings Re-
store
[`A;Lo] Alarm Low Set
Point
[`A;hi] Alarm High Set
Point
[`A;hy] Alarm Hysteresis
[CUSt] Custom Menu
[StPt] Set Point
[AC;pu] Active Process
Value
[AC;SP] Active Set Point
[``op] Open Loop Set
Point
[`AUt] Autotune
[`C;M] Control Mode
[`h;Pr] Heat Power
[`C;Pr] Cool Power
[``ti] Time Integral
[``td] Time Derivative
[``db] Dead Band
[`h;Pb] Heat Proportional
Band
[`h;hy] Heat Hysteresis
[`C;Pb] Cool Proportional
Band
[`C;hy] Cool Hysteresis
[`r;rt] Ramp Rate
[t;tUn] TRU-TUNE+
®
En-
able
[idLE] Idle Set Point
[P;Str] Profile Start
[P;ACr] Profile Action Re-
quest
[gSd1] Guaranteed Soak
Deviation 1
See:
Home
Page
- - - - - - - - - - - - 14005 uint
RWES
[`iid]
[ iid]
Custom (1 to 20)
Instance ID
Select which instance of
the parameter will be se-
lected.
1 to 4 - - - - - - - - - - - - - - - - 14003 uint
RWES
[`LoC]
[FCty]
Security Setting Menu
[LoC;o]
[LoC.o]
Security Setting
Operations Page
Change the security level
of the Operations Page.
1 to 3 2 - - - - - - - - - - - - 3002 uint
RWE
Note:
Some values will be rounded off to fit in the four-character display. Full values can be
read with other interfaces.
If there is only one instance of a menu, no submenus will appear.
R: Read
W: Write
E: EEPROM
S: User
Set