Installation Manual

ManualsBrandsWattstopper ManualsAccessoriesMounting Brackets

Wattstopper

DLM - Photosensor Mounting Brackets

Installation Instructions • Instructions d’Installation • Instrucciones de Instalación

No: 24616 – 10/16 rev. 1

Catalog Number • Numéro de Catalogue • Número de Catálogo: LMLS-MB1-MB2

Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China

DESCRIPTION

The LMLS-MB1 and LMLS-MB2 mounting brackets provide the flexibility to mount the LMLS-400 and LMLS-500 Photosensors to walls,

skylight wells, or J-Boxes. They are specifically designed to be used in conjunction with these Photosensors.

LMLS-MB1 J-Box Mounted

LMLS-MB2 Skylight Wall Mounted

SPECIFICATIONS

Material: ..................................................... ABS, UL 94 5V

..........................................Flame Retardant Material

.........................................................Indoor Use Only

Mounting Options:

LMLS-MB1 ........................................4-Square J-Box

............................................................ 2-Gang J-Box

LMLS-MB2 ...........................................Screw to Wall

...........................Tape to wall with double sided tape

LMLS-MB1

LMLS-MB2

Surface Mount using LMLS-MB1 Mounting Bracket

Ceiling Mounting bracket

Ceiling or Ceiling Tile

Surface Mount

using LMLS-MB2

Mounting Bracket

Mounting bracket

Cabling

Remove

tab

Skylight light well

Summary of content (4 pages)

PAGE 1
Wattstopper ® DLM - Photosensor Mounting Brackets No: 24616 – 10/16 rev. 1 Installation Instructions • Instructions d’Installation • Instrucciones de Instalación Catalog Number • Numéro de Catalogue • Número de Catálogo: LMLS-MB1-MB2 Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China SPECIFICATIONS Material:...................................................... ABS, UL 94 5V ...........................................Flame Retardant Material ..........
PAGE 2
LMLS-MB1 MOUNTING OPTIONS Hole for 4"Square J-box 2-gang The LMLS-MB1 is designed to be able to mount to a standard 4” square junction box as well as a 2-gang junction box. Using a small screwdriver, punch out the holes for the corresponding junction box. Holes are clearly marked on the rear side of mounting plate.
PAGE 3
LMLS-MB2 MOUNTING WITH SCREWS 1. Use template to mark wall with appropriate hole spacings. 3. Use provided screws to mount the LMLS-MB2 to the wall. 2. Drill screw pilot holes using #40 drill bit. 0.098"pilot holes Align screw holes on mounting bracket to markings on wall. Hole size diameter to drill for cable is 0.875" Placement Example when mounting with screws Mounting when running the RJ-45 cable through wall. Mounting when running the RJ45 cable on the wall surface. 0.
PAGE 4
Placement Example when mounting with double sided tape Mounting Instructions Mounting when running the RJ45 cable on the wall surface. Mounting when running the RJ-45 cable through wall. Apply tape to rear recess as shown. Tape Or Cable goes through wall Cable goes on wall surface Template hole size diameter to drill for cable is 0.875". Visually align to markers on wall, then press on wall.