Installation Guide

Watch and Assemble www.waybasics.com/help-monitor-stand Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share

Important

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

1 2

3 4

Carefully remove the 3M protective layer,

insert alignment pin to connect back

and side zBoards.

Carefully remove the rest of the 3M protective layers.

Place alignment pins in vertical zBoards.

Connect the horizonal zBoard with the

assembled back and side zBoards.

Easy, done! Maximum weight capacity 30 pounds.

Visit links below for more details.

Enjoy building possibilities!

2 Side zBoards

adhesive strips on 2 edges

1 Horizontal zBoard10 Pins

2 Back zBoards

adhesive strips on 2 edges

Included

WARNING: CHOKING HAZARD

Small parts NOT for children under 3 years

MONITOR STAND

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

• When moving your Way Basics furniture, lift from the bottom

• Make sure zBoard surfaces are clean and dry

PAGE 1
MONITOR STAND • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your Way Basics furniture, lift from the bottom • Furniture is for indoor use only • Make sure zBoard surfaces are clean and dry Included 10 Pins 2 Back zBoards adhesive strips on 2 edges 1 Horizontal zBoard 1 Carefully remove the 3M protective layer, insert alignment pin to connect back and side zBoards. 2 Carefully remove the rest of the 3M protective layers. Place alignment pins in vertical zBoards.