user manual

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
15
Tools Needed:
Tools Needed:
INSTALLATION
Vertical Track
IMPORTANT: THE TOPS OF THE
VERTICAL TRACKS MUST BE LEVEL
FROM SIDE TO SIDE. IF THE BOTTOM
SECTION WAS SHIMMED TO LEVEL IT.
THE VERTICAL TRACK ON THE SHIMMED
SIDE, MUST BE RAISED THE HEIGHT OF
THE SHIM.
Position the left hand vertical track
assembly over the rollers of the bottom
section. Make sure the counterbalance
cable is located between the rollers and
the door jamb. Drill 3/16” pilot holes for
the lag screws. Loosely fasten jamb
brackets and flagangles to the jamb
using 5/16” x 1-5/8” lag screws.
Tighten lag screw securing bottom
jamb bracket to jamb, to maintain
5/8” spacing. Hang cable drum over
flagangle. Repeat for the right side.
BOTTOM
SECTION
BOTTOM SECTION
VERITCAL TRACK
ROLLER
5/16” X 1-5/8”
LAG SCREWS
FLAGANGLE
VERTICAL
TRACK
ASSEMBLY
CABLE
DRUM
JAMB
BRACKET
3/16” Drill Bit
Power Drill
7/16” Socket
Driver
Tape Measure
Level
5/8”
7
LAG
SCREW
QUICK INSTALL
JAMB BRACKET
QUICK INSTALL AND FULLY ADJUSTABLE
FLAGANGLE LAG LOCATIONS
LAG
SCREW
LOCATIONS
LOCK SECTION
Stacking Sections
NOTE: For door section identification
see page 4.
NOTE: Make sure hinge leafs are flipped
down, when stacking another section
on top.
Place rollers in hinge tubes of the
second section (lock section). With
assistance, lift second section and
guide rollers into the vertical tracks.
Align vertical marks in the upper
alignment sticker, with the lower
alignment sticker on right hand side
on the back of door. Keep sections
aligned and fasten hinges to connect
the sections using 1/4” - 14 x 5/8”
self-tapping screws. Repeat for other
section(s) except top section.
IMPORTANT: WHEN SECURING THE END
HINGES TO THE SECTIONS WITH 1/4”
- 14 X 5/8” SELF-TAPPING SCREWS,
ENSURE THEY ARE ATTACHED AS
SHOWN IN THE ILLUSTRATIONS ABOVE.
8
Power Drill
7/16” Socket
Driver
RIGHT END HINGE
327985 NEW 9-04-06
327985 NEW 9-04-06
(2) 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS
LEFT END HINGE
327985 NEW 9-04-06
327985 NEW 9-04-06
(2) 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS
ALIGNMENT
STICKERS