user manual

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
16
Tools Needed:
Tools Needed:
9
Operator Bracket
Power Drill
7/16” Socket
Driver
NOTE: If installing a trolley type operator,
complete this step. If not, skip this step and
continue with step 10.
IMPORTANT: WHEN INSTALLING A TROLLEY
TYPE OPERATOR ON 9800 DOOR, A WAYNE-
DALTON TROLLEY BRACKET MUST BE
SECURELY ATTACHED TO THE TOP SECTION.
IT IS THEN UNNECESSARY TO FURTHER
REINFORCE THE TOP SECTION OF THE
MODEL 9800 WAYNE-DALTON DOOR, WHEN
ATTACHING A TROLLEY TYPE OPERATOR,
AS LONG AS THE INSTALLATION OF THE
OPERATOR IS ACCORDING TO INSTALLATION
INSTRUCTIONS AND OWNER’S MANUAL
AND FORCE SETTINGS ARE ADJUSTED
PROPERLY.
Remove, but retain (4-6) 1/4”- 20 x 7/8”
self drilling screws from the center of the
u-bar, allowing the operator bracket to slide
between the section and the u-bar.
NOTE: For retro fit applications, the operator
bracket must be aligned with an existing
operator
Locate the center of the top section and
slide operator bracket under u-bar till the
operator bracket is seated against the u-bar
flange. NOTE: Prior to fastening operator
bracket to top section, ensure the top edge
of operator bracket is aligned with the top
edge of the section as shown on far right.
Attach the operator bracket using (6) 1/4”-
20 x 5/8” self drilling screws (as shown).
Finish re-attaching the u-bar using the self
tapping screws removed previously.
OPERATOR
BRACKET
U-BAR
SIDE VIEW OF U-BAR
U-BAR
OPERATOR BRACKET IN
PLACE UNDER U-BAR
(6) 1/4”-20 X 5/8”
SELF DRILLING
SCREWS
Stacking Sections
IMPORTANT: PUSH & HOLD THE HINGE
LEAFS AGAINST SECTION WHILE
SECURING WITH 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS. END HINGES
HAVE (2) SCREWS AND INTERMEDIATE
HINGES HAVE (3) SCREWS.
NOTE: Install lock at this time (sold
separately) see instructions in
OPTIONAL SIDELOCK INSTALLATION on
page 33.
8
Power Drill
7/16” Socket
Driver
(2) 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS
END HINGES (LEFT HAND SHOWN, RIGHT HINGE SYMMETRICALLY OPPOSITE)
INTERMEDIATE HINGES
(3) 1/4” - 14 X 5/8”
SELF-TAPPING
SCREWS
327985 NEW 9-04-06
327985 NEW 9-04-06
INTERMEDIATE HINGE
(3) 1/4” - 14 X 5/8” SELF-TAPPING SCREWS
OPERATOR
BRACKET
U-BAR
SIDE VIEW OF U-BAR WITH
OPERATOR BRACKET INSTALLED
OPERATOR
BRACKET
U-BAR
TOP OF
SECTION
TOP EDGE OF
OPERATOR
BRACKET
1/4”-20 X 7/8”
SELF DRILLING
SCREWS