user manual

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
24
Tools Needed:
Tools Needed:
Drive Gear Installation
End Brackets
Lubricating Oil
Beginning with the right hand side,
lubricate entire circumference of the
drive gear with the lubricating oil
provided. Slide the drive gear onto the
winding shaft splines until it touches
the flagangle.
NOTE: On single spring applications,
no drive gear is required on the left
side.
NOTE: If additional lubricating oil is
needed, use “Dura Lube
®
Engine Oil
Treatment”.
WINDING
SHAFT
SPLINES
DRIVE
GEAR
FLAGANGLE
DRIVE
GEAR
WINDING
SHAFT
CABLE
DRUM
CABLE
DRUM
IMPORTANT: WARNING TAGS MUST BE
SECURELY ATTACHED TO BOTH END
BRACKETS.
Slide the right hand end bracket over
the drive gear and fasten to the
flagangle using a #10 self-tapping
screw.
Drill 3/16” pilot holes into jamb for the
lag screws. Secure end bracket and the
flagangle to the jamb using
(2) 5/16” x 1-5/8" lag screws.
Repeat for left hand side.
Power Drill
3/16” Drill Bit
7/16” Socket
Driver
Phillips Head
Screwdriver
18
19
LUBRICATING
OIL
(2) 5/16” X 1-5/8”
LAG SCREWS
#10 PHILLIPS
HEAD
SCREW
WARNING
TAG
END BRACKET