user manual

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
31
Tools Needed:
Tools Needed:
INSTALLATION
CABLE
DRUM
Drum Wrap Installation
Drum wraps are identified as right and
left hand.
To install, place the right hand drum
wrap over the cable drum and under
the idrive
®
disconnect cable. Align the
outside flange over the outside edge of
the cable drum and push the drum
wrap down onto the cable drum. Repeat
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
IMPORTANT: RIGHT AND LEFT HAND
IS ALWAYS DETERMINED FROM INSIDE
THE GARAGE LOOKING OUT.
DRUM
WRAP
CABLE
DRUM
DRUM
WRAP
None
OUTSIDE
FLANGE
Rear Support
KEEP HORIZONTAL TRACK PARALLEL
AND WITHIN 3/4” MAXIMUM OF DOOR
EDGE, OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE INJURY OR DEATH.
Raise the door until the top section and
half of the next section are in a horizontal
position. Do not raise door any further
since the horizontal track are not yet
supported at the rear.
RAISING DOOR FURTHER CAN RESULT
IN DOOR FALLING AND CAUSE SEVERE
INJURY OR DEATH.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side, just below the second roller on the
other side. This will prevent the door from
raising or lowering while installing the rear
support.
Using perforated angle, 5/16” x 1-5/8”
hex head lag screws and 5/16” bolts
with nuts (may not be supplied), fabricate
rear support for horizontal tracks. Attach
30
31
WARNING
WARNING
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Level
Hammer
Tape Measure
DOOR IN THE
UP POSITION
VERTICAL
TRACK
3/4”
VICE
CLAMPS
DOOR EDGE
HORIZONTAL
TRACK