user manual

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
32
Tools Needed:
horizontal tracks to the rear supports with
5/16”-18 x 1-1/4” hex bolts and nuts (may
not be supplied). Horizontal tracks must be
level and parallel with door.
NOTE: If rear supports are to be installed
over drywall, use 5/16” x 2” hex head lag
screws.
NOTE: If an idrive
®
opener is installed,
position horizontal tracks one hole above
level when securing it to rear supports.
Adjust weather seal or door stop (if
necessary). Now permanently attach the
weather seal or door stop to both door
jambs and header. (They were temporarily
attached in PREPARING THE OPENING on
page 10.) Avoid pushing weather seal or
door stop too tightly against face of door.
PRIOR TO WINDING OR MAKING
ADJUSTMENTS TO THE SPRINGS,
ENSURE YOU’RE WINDING IN THE
PROPER DIRECTION AS STATED IN THE
INSTALLATION INSTRUCTIONS. OTHERWISE
THE SPRING FITTINGS MAY RELEASE FROM
SPRING IF NOT WOUND IN THE PROPER
DIRECTION AND COULD RESULT IN SEVERE
OR FATAL INJURY.
Now, lift door and check it’s balance.
Adjust, if door lifts by itself (hard to pull
down) or if door is difficult to lift (easy to
pull down). Anytime spring adjustments are
made you must loosen the lock nuts before
beginning adjustments. Retighten both lock
nuts after completion. To adjust spring(s),
only add or remove 1/4 turn on the counter
at a time. Adjust both sides equally.
IMPORTANT: DO NOT ADD OR REMOVE
MORE THAN 1 SPRING TURN FROM
SPECIFIED AMOUNT. IF THE DOOR STILL
DOES NOT OPERATE EASILY, LOWER THE
DOOR TO THE CLOSED POSITION, UNWIND
SPRING(S) TO ZERO, AND RECHECK THE
FOLLOWING ITEMS:
1.) Check the door for level.
2.) Check the TorqueMaster
®
spring tube
and flagangles for level and plumb.
3.) Check the distance between the
flagangles - must be door width
plus 3-3/8” to 3-1/2”.
4.) Check the counterbalance cables
for equal tension - adjust if necessary.
5.) Rewind the spring(s).
6.) Make sure door isn’t rubbing on jambs.
NOTE: As a safety feature, the right hand
end bracket cannot be disassembled
for service until the spring is completely
unwound and the counter cover reads zero.
After door installation is completed, refer to
the idrive
®
owner’s manual to complete the
idrive
®
installation.
Rear Support Continued...
PERFORATED ANGLE
(3) 5/16”
BOLTS & NUTS
HORIZONTAL TRACK
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
ANGLE
BRACE
PERFORATED ANGLE
- BOLTED USING (2) 5/16”
X 1-5/8” HEX HEAD LAG
SCREWS TO CEILING
MEMBER AND PARALLEL
TO DOOR
SOUND FRAMING MEMBERS
SOUND FRAMING MEMBERS
HORIZONTAL TRACK
ANGLE
BRACE
BOLT MUST EXTEND INTO
THE TRACK TO SERVE AS
A ROLLER STOP
PERFORATED ANGLE -
BOLTED USING (2) 5/16”
X 1-5/8” HEX HEAD LAG
SCREWS TO CEILING
MEMBER AND PARALLEL
TO DOOR
JAMB
WEATHER
SEAL
PERMANENTLY ATTACHED
WEATHER SEAL
WARNING